This Homebrew Kegging System Includes:
- TapRite T-Handle Dual Gauge Regulator
- Two Used 5 Gallon Pin Lock Corny Kegs
- Double Gas line assembly with MFL fittings, Fifteen (15) feet of Thick Wall Gas Line (details below)
- Two 4 1/8" Faucet Shank Assemblies with MFL disconnects
- Faucet wrench
This gas line set up assumes you keep the Co2 Tank outside of your kegerator and run the line inside to a "T" connector:
-6 feet of line to connect the regulator to a "T" connector
-6 feet of line & gas disconnect for the first keg (long so you can bring the keg outside of the fridge to shake/force carbonate)
-3 feet of line and gas disconnect for the second keg
(As of 2-17-2014 we are throwing in a set of O-rings for each keg with every purchase of this kegging system.)
This system should be run at 10 PSI.
Measure your fridge wall to ensure a 4-1/8" shank will do the job, it will span 2-1/2". We recommend installing the shank using a 7/8" hole saw.
The gauge guard is a great way to protect your regulator and highly recommended here at AIH, please see our options!
Our CO2 tanks speak for themselves. If you can rent one locally, go for it. If not...we have some darn good prices!
Full Set of instructions is now available online to save paper:
Homebrew Kegging System Pin Lock(PDF)
We know some homebrewers are more picky than others, so please keep in mind that these are USED kegs. Some of these kegs are probably 30 years old. Do not expect new kegs. If you are looking for new kegs, please check out our new kegs. We try and have quality kegs available at all times. With this said, they are going to show normal wear and tear. We are not implying that our kegs are not quality...we just want to avoid any misunderstandings.
If you are unhappy with your used 5 gallon kegs for any reason, we will gladly take them back. The purchaser will be responsible for return shipping charges.