This high output jet propane burner and stand will support most homebrew kettles.
- Single high pressure jet burner
- 10 psi propane regulator, with 28" of LP Hose
- Also includes a dial thermometer (100-750 F)
-Some assembly required
- 16" diameter burner surface
- 12" tall
- 20" diameter heat and wind shield
If you are not getting the best flame possible out of your propane burner, you may have triggered a safety valve in the propane regulator body. This occurs when the gas flow through the regulator is too great. You will need to disconnect the regulator from your propane tank to release the safety valve. While connecting your regulator to your propane tank, it is very important that the propane tank and all needle valves are completely closed. Once the regulator is correctly connected to your closed tank, open the propane tank slowly to allow gas to flow into the regulator. You can now open the needle valve enough to ignite your burner. Once the burner is lit you can slowly open the needle valve until you reach the desired flame intensity.