Beer Brewing and Kegging Supplies • 1-313-277-2739 • Serving Homebrewers Since 1999
0 item(s)
USA, Canada, Global Shipping
$16 Off Orders Over $100! View Terms

3 Burner Hose Assembly

3 Burner Hose Assembly

Item Number:99-2093
Your Price:$93.99

Choose Options and Quantity

Add an Orifice?
add 1 please [+$3.99]
Add 2 please [+$6.99]
Add 3 please [+$9.99]
No thank you
Add a Burner?
Add 1 please [+$13.00]
Add 2 please [+$24.98]
Add 3 please [+$35.99]
No thank you
Reward Points 94 points will be rewarded to you when you buy this item.
Complete assembly for a 3 burner system and includes:
1- 30 PSI Regulator
3- 6' ft Black High Pressure Hose 350-PSI 1/4'' x 3/8'' Brass Flare
1- 1/4'' Brass 4 way
1- Brass 1/4''x1/4'' x 1.5'' Fitting
3- 1/4'' Needle Valves
Assembly comes already assembled for your convenience, if you need burners or an orifice for each burner (connects hose to burner) please see the options below.  

Propane Troubleshooting:

If you are not getting the best flame possible out of your propane burner, you may have triggered a safety valve in the propane regulator body. This occurs when the gas flow through the regulator is too great. You will need to disconnect the regulator from your propane tank to release the safety valve. While connecting your regulator to your propane tank, it is very important that the propane tank and all needle valves are completely closed. Once the regulator is correctly connected to your closed tank, open the propane tank slowly to allow gas to flow into the regulator. You can now open the needle valve enough to ignite your burner. Once the burner is lit you can slowly open the needle valve until you reach the desired flame intensity.

5 Stars
Doesn't smell like farts
Fuels my 3 burner, 8 gallon setup no with no problems. A very simple solution, way easier than piecing everything together in some convoluted diy project I had originally planned. Does not smell like farts. Cheers!
Reviewed by:  on 3/30/2018
5 Stars
Three burner system
I went from a 5 gallon one burner system to 25 gallon three banjo burner system. This is the fuel supply system I use for it. It has been in use for close to 2 years now and has done everything I have asked of it. I originally built the system myself and wanted to go hard pipe with the controls in the front of the system, but have not gotten there yet, this was a compromise (have to walk around to the back of the brew sculpture to adjust), but this is not a problem at all. It has been a great piece of equipment and I have brewed close to 35 batches with it. Highly adjustable via macro and micro nobs.
Reviewed by:  on 1/29/2016