Chugger 230 V Center Inlet SS Head

Chugger 230 V Center Inlet SS Head

Model: Chugger-SS Center-2

Inlet 3/4" MPT Outlet 1/2"MPT

316 STAINLESS STEEL (Front Housing), 316 Stainless Steel (Rear Housing), Teflon (Thrust Washer), CLEAR Silicone (O-Ring), POLYSULFONE (Impeller)

Max Flow 7 GPM 22.7 LPM
Max Head 18.6 FT 4.1 M
Power 1/20 HP .029 KW
Electrical 230V 50/60HZ
Submersible Non-Submersible

Max Flow 7 GPM 22.7 LPM
Max Head 18.6 FT 4.1 M
Power 1/20 HP .029 KW
Electrical 230V 50/60HZ
Submersible Non-Submersible

Max Flow 7.3 GPM
Max Head 18.9 FT
Power 1/20 HP

Can handle liquids of 250F
Materials are FDA Food Compliant
Components are UL Recognized

The Chugger Pump is shipped ready for installation. Directional arrows on the pump head show fluid direction through the pump. The four screws on the pump head may be removed and the pump head can be rotated as required to fit your piping system. Check out "How to Change a Chugger Pump Orientation Video".

The motor should be oiled yearly with 4-5 drops SAE20 weight non-detergent oil, do not over oil.

Follow all local electrical safety codes and always disconnect power before performing work on or near the pump motor.

Chugger Pumps are warranted only against defects in workmanship for a period of 6 months from the date of purchase. DO NOT RUN THE PUMP DRY, it will not be covered under warranty. 

A SQUEALING SOUND IS A WARNING YOU ARE RUNNING THE PUMP WITH NO FLUID POWER OFF IMMEDIATELY