Q: I have a two way gas distributor and would like to connect a regulator to one of the 1/4" MFL outputs to reduce the pressure to the lower of the two beers I have on tap. Would this regulator connect easily to one of the 1/4" MFL outputs? If not, what would you recommend in this situation? Thanks!
A: if you have mfl fittings on the manifold, you would need a length of 5/16" ID gas line tubing to connect from the barb on the regulator, to a swivel to barb connection like item ID 91-2650a that would connect to the manifold
Q: Can the screw that adjusts the pressure be replaced with a t-handle screw?
A: With the correct screw and bonnet, this could potentially be changed over to a T-handle if needed or purchasing the regulator on part ID C384-3741T would already have a T handle in place, and include the High pressure inlet feed gauge as well, at a lower cost
Q: Can the Safety Relief Valve for Co2 Regulator/Manifolds Item Number:73-RLAPRV sold on this website be used on this item?
A: The regulator shps with a terminal pressure valve, btu should have a 1/4" connection or thread to apply a manual valve if needed as a seperate item
Q: How do I get a replacement o-ring for this regulator? (where it seals to CO2 tank connection) What size is it?
A: The part your looking for is c384-44017R on our site to reorder
Q: I want to use this regulator with a paintball CO2 tank. Will I need the right hand or the left hand thread adapter?
A: You would need the left hand thread adapter.
Q: Hi, Would you consider substituting a 0-30lb gauge for this deal?
A: Sorry, we do not modify regulators.
Q: If I wanted to get a barb to daisy-chain two of these together to make a regulator assembly, what size barb would I need? 1/4" MPT?
A: You would need this item c384-6618bl-2, (taprite primary's are left hand on the pass thru).
Q: Can this regulator be used in-line with other regulators for 2 or more separate gas supply lines?
A: You can definitely connect other regulators to this unit to create a multiple body regulator, or run secondary regulators down stream. This will not be an issue.
Q: Is there any way to use this regulator with your manifolds that have 3/8" barbed connections?
A: This will attach to our manifolds with a 5/16" ID thick gas line.
Q: Does the rear of this regulator (Item number C384-3741E) have threaded holes to panel mount the regulator?
A: This regulator does have a threaded hole in the center to be used for mounting.